Aluminum Ground Stake for Flag Poles

• Comes with top cap
• Imported

Suggestions for proper installation of Aluminum Ground Stake

Additional materials you will need:

• 5lb hammer (Post Driver is safer but more expensive)
• 4' pipe, slightly smaller OD than ground sleeve
• Post & Pipe Three Axis Level (recommended)

Instructions:

• Mark 4' pipe 8 inches from the bottom.
• Attach Three Axis Level to pipe.
• Position pipe vertically at location where you want to install ground sleeve.
• Pound pipe into ground up to 8 inch mark.
• Wiggle pipe out of ground.
• Insert the ground sleeve into hole.
• Place block of wood on top of ground sleve and press or pound ground sleeve flush with ground.
• Ensure ground sleeve is deep enough to avoid lawnmowers and tripping hazards.
• If ground is extremely hard, pour a bucket of warm water over the work area a few minutes before installation.